Battery Disconnect

[Corey C]

That looks good !!

[bcshineon]

That is awsome. Ive been trying to figure out where to install one on my boat and you sovlved that for me. Clean and neat installation. What material did you use for the base?

[brennansgranpa]

Well done – that is some very fine work!

[RazorCat]

Very nice job. Is that disconnecting components wired to the start battery before charging?I always wondered if that was necessary, or at least, preferred. Never disconnected anything before charging (HDS units are removed when garaged and MG TM is switched off). Should I be???

[Corey C]

My triton had a one piece box that had two switches like that , one for starting batt and one for trolling motor , if shut off the batteries stayed full , if not they needed topped off every two weeks , i feel they make a big difference on battery life , that being said i have searched for a similar switch for my cat and no luck yet .

[catdude28]

Very nice install. I have to do something like that for my Talon so I can shut it off while trailering to prevent accidental deployment.

[Jones TrollingMotor]

Nice clean looking install. In my opinion, a battery cutoff switch should be on every cranking battery, and on the positive wire of the trolling motor battery.JohnJones Trolling Motor Services870 773 3474Motorguide/MinnKota/PowerPole/Lowrance/Humminbird

[NacCat]

How is the disconnect switch working out? Has the motor being routed through that switch caused any problems?Thanks,Mike

[Author]

Posts