Eyra 2 Graphs on Bow

[acfcat2]

Give me to the end of the week and i will have a Balzout dual set up i can show you.

[Limbhanger51]

Sounds good!

[John in Little Rock]

I’ll see if I can’t post a picture tonight.

[abarbour]

[Swimrunbike]

I’m inquiring how you were able to do the actual mounting process.  With my Eyra, there’s no way I could take my arm and reach from the trolling motor plug plate access to that far right of the bow. Nor do I have an access hatch located underneath the trolling motor pedal as some may have installed on their Eyra.   So I’m curious to know how you were able to bolt the frame down to the bow recessed area.  Thanks.

[John in Little Rock]

My set up is the same as Abarbor above.  I know that an access hatch had to be cut beneath the trolling motor pedal on my previous Eyra.

[mike dominick]

I have the same BBT mount on my Lynx, it’s fantastic and strong.  You may already have a 4 inch access hatch under your trolling motor pedal, pull it and see, otherwise it’s an easy job and Alan in Parts will get you a cover and the screws needed

[abarbour]

I cut a 4 inch access hole under the trolling motor to gain access. I then installed an access panel over the hole to gain future access. Very easy install.

 

 

[Author]

Posts