Owner's Board

Installing Trailer Step

I got the new step (no pole) to install on my trailer, PIV with dual axles. Now the question is, where exactly on the tongue should it be installed? I know it needs to clear when I use the swing away but theres not much space there on the tongue. The box it come in (by UPS) had one side ripped open and if there were any instructions, they fell out, along with the two mooring ropes that didnt arrive but were on the shipping list.

This topic has 5 replies, 2 voices, and was last updated 17 years, 8 months ago by Bass Cat Boats.

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
August 20, 2007 at 4:48 pm #340178

Bass Cat Boats
Keymaster

Mad Dog, give us a call on the instructions and well give you some measurements on the drilling locations. Tell them about the missing parts as well and well make sure that is taken care of as well.Thanks,BCB

August 20, 2007 at 6:35 pm #340206

Bass Cat Boats
Keymaster

Made the call and talked to Bobby. Everythings taken care of. Thanks very much for your help.

August 20, 2007 at 8:48 pm #340226

Bass Cat Boats
Keymaster

Good! Glad they for ya covered!BCB

August 21, 2007 at 12:28 am #340247

Bass Cat Boats
Keymaster

I must say UPS is having an issue getting these delivered without ripping the box to shreds.DESERTDWELLER.COM “GET YOUR BASS IN THE BOAT”

August 21, 2007 at 12:35 am #340262

Bass Cat Boats
Keymaster

Yes, it is the metal cutting the cardboard when the throw the boxes around. Usually not the route drivers on either end, though handlers in between. BCB
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic. Login Register