Just received my new bucket seats to replace my 2001 Pantera Classic bench seats and they look fantastic, but I have a few questions: I have a bag with bunch of screws, bolts, nuts, rivets and caps and not sure what goes where. I figure the rivets are used to attach the hinges of the center seat to the fiberglass. (I guess you gave me extra rivets or is there anything else I should rivet) What size hole to I need to drill for the rivets? I also have six 2-1/2″ SS screws and figure this is for the two buckets. I guess you use 3 screws per bucket and I was going to put one screw in the middle of the two hinges at the front of the seat and one screw through the back of the seat just below the padding (do I drill through the vinyl?). Do I have to worry about the screw going through my livewells behind the seats? The six bolts with locking nuts are use to attach the hinged backrest for the center seat? and I guess you drill your holes down into the cooler? I was also given 10 black end caps and not sure exactly where they should be but I figure 4 of them are for my butt seat I ordered, too. Are the rest used for the center seat back rest? Lastly, I did not receive any of the decorative tape at all to cover up the holes that will be left form the rivets that were used to attach my old bucket seats. Should I have received some? If anyone could post a picture of the new buckets on there boat with the seats opened I would really appreciate it. Thanks for you help in advance and will call BCB tomorrow if I still need assistance. God Bless, Stephen