I have a 2013 P2 with a MG trolling motor and when I turn the speed past 5 to quickly more to another spot, it only runs for 1 minute or 2 then looses power, like it is may only be running on 12 v (studdering).If I reset it at 5 or below it runs fine for moving.how can I tell if it is a motor issue or where else should I check?im not very experienced in running down electrical issues, but any suggestions would be appreciated.thanks
Check all connections . — Sounds like it loses contact under high amp load , which indicates a weak connection , Circuit breakers , as BCB suggested , are the place to start .
I have a Minn Kota that shuts off when running it at 90% or greater. It starts back without me doing anything except pushing the foot switch. Im guessing its the same issue? Any help appreciated.
BCB nailed it. Circuit Breakers. When you replace them make sure that they sit so they shed any water. Clean connection lugs and apply corrosion protection to all connection points. Should be good to go.Practice Angling CPRCatchPictureRelease2010 PIV 200SHO
Author
Posts
Viewing 7 posts - 1 through 7 (of 7 total)
You must be logged in to reply to this topic. LoginRegister