Owner's Board

motor setup cougar w/250 pro xs

i am trying to set up my 09 cougar..26 fury/250 merc/manual jackplate.........from factory the 2 parts of plate were flush..i have raised it as much as 1" and handles better but lost little speed..turning @6000 in this 90 degree water and gps @75 pretty loaded..read on here about 80mph quite often and wondering how to set up..when measuring from bottom centerline of boat do you measure from lowest point or bottom of groove that is in center of hull...seems about 3 1/2 inches from lowest point now..any suggestions??

Home Forums Bass Cat Boats motor setup cougar w/250 pro xs

Viewing 4 posts - 1 through 4 (of 4 total)
Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic. Register

Skip to toolbar