Owner's Board

Need some quick set-up help on a 07 Puma 250 XS

I have a good friend that is in the process of buying an 07 Puma with a 250 Pro XS on the back with 26 Trophy, slide master jack plate with the plates set even.. He called me up horrified about the way it rode in rough water and the water was not that rough. He said that the going through waves was fine but the side to side action was un-tolerable at 64mph. I was thinking that he was trimming to much and suggested that trim no more than half at full throttle. He said that it helped some but was not enough to convince himself to buy the boat. Also stated that the hole shot was very bad. He is coming out of a 21ft Bullet and is aware that the boats are two different animals so he is willing to learn and wants the boat bad. He has a 25 Fury and a 27 T-1, I told him to throw the Fury on and I will go with him tomorrow for a couple of runs. What is a good starting point on the jack plate for the 25 Fury or should I tell to put the 27 T-1 on?I drove this boat to 76 a couple of years ago but I am not sure if the set up has been messed with. I would love to extend the BCB family by helping him with driving and setup. The motor only has 27 hours on it!!!!Last edited by LA Elwood on July 24th, 2013, 9:23 pm, edited 1 time in total.Elwood.....Bass Cat Proud

Home Forums Bass Cat Boats Need some quick set-up help on a 07 Puma 250 XS

Viewing 8 posts - 1 through 8 (of 8 total)
Viewing 8 posts - 1 through 8 (of 8 total)

You must be logged in to reply to this topic. Register

Skip to toolbar