New seats

[Bass Cat Boats]

Glad you were pleased with their service! BCB

[jbassertn]

my seats have 2 screws in the front bottom took them out and bottom cushion cam off then there were 2 screws that went into boat threw bottom frame of seat also a screw that went threw back of seat that was hidden by bottom cushion after it was reinstalled any problem let me know and ill send you some pic

[cpcat]

Thanks, jbassertn, I am replacing on a 98 jag. I noticed two open holes on the front hinge for bottom mounting is that the only place to mount the bottom. For the back I was wondering does the center Cushing for your back come out to drive screws in fiberglass and then put Cushing back. Chris

[jbassertn]

no my center back does not come off there is a screw threw it about 2 inches up where bottom cushion will hide it when re installed mine also do not hinge I have no storage under them just fuel

[FishStalker]

Matched real niceSent from my iPhone using Tapatalk

[TonyCrafton]

Thanks. I gave Allen in parts the HIN from the boat and he did the rest.1997 Pantera Classic1999 Mercury 200 OptiMax25 Pitch TempestBobs 6″ Action Hydraulic Jack Plate

[schodackbassman]

They look great!

[Nelson2014]

Very niceSent from my iPhone using Tapatalk

[TonyCrafton]

Thanks all.I ended up with a gap on the outside of each seat. I am think of making a storage box to go there. On the passenger side I am thinking of putting a slant in it for rods to lay on with a strap to hold them down. We saved the piano hinges just because. The lids for them my be a good place to use them.1997 Pantera Classic1999 Mercury 200 OptiMax25 Pitch TempestBobs 6″ Action Hydraulic Jack PlateLast edited by TonyCrafton on February 18th, 2018, 12:38 am, edited 1 time in total.

[Youngblood93]

TonyCrafton wrote:Thanks all.I ended up with a gap on the outside if each seat. I am think of making a storage box to go there. On the passenger side I am thinking of putting a slant in it for rods to lay on with a strap to hold them down. We saved the piano hinges just because. The lids for them my be a good place to use them.1997 Pantera Classic1999 Mercury 200 OptiMax25 Pitch TempestBobs 6″ Action Hydraulic Jack PlateYou can never have enough cup holders…Sent from my Moto Z (2) using Tapatalk

[TonyCrafton]

Cup holders is a good thought too.1997 Pantera Classic1999 Mercury 200 OptiMax25 Pitch TempestBobs 6″ Action Hydraulic Jack Plate

[NJBass]

Wow….those seats look great.

[Ryan2005]

When I did my mine a few years back I got some tackle webs and put them on both sides. They just stick on and worked great. Covered the holes from the bench seats as well. Sent from my SAMSUNG-SM-G935A using Tapatalk

[ILBassAddict]

Yes. I just replaced the seats on my 2006 Pantera Classic. The seats are much more comfortable. My wife agrees as well. I will say that it feels like I am sitting a couple of inches higher with the new seats, so I had to get used to the position of the shifter/throttle again.Note, the seat frame was a slightly different size, so you might need to install new anchors in the seat pan.

[Bearkat]

Thank you. Mine have a couple tears in the seams that I was going to have fixed, but am considering replacing them all together. Mine tend to bottom out in rough water.

[Author]

Posts