Power pole installation Lynx

[mike dominick]

I need to do the same, has anyone put one on each side?

[mike sanders]

Mine are both mounted on port side from Bass Cat.

[proptwister]

Just had 10′ poles installed on mine.  Both pumps fit nicely in the port side rear compartment.

[jclacy]

Thanks so much for the replies, guys. One more question:  Are the hydraulic lines run a) with thru-hull fittings, b) through existing holes, or c) were new holes cut/drilled?  Thanks again.

[proptwister]

[proptwister]

Thru hull fitting.

[jclacy]

Looks great!  I really appreciate your effort. The willingness of fellow  owners to help others is one of many reasons I returned to Basscat.

[proptwister]

No problem.

[SixBoss]

Sorry fo the late reply – I did dual 10’s on my Lynx – one per side on the “shelves”.  For me I wanted them placed on the side they were associated with in order to prevent adding to the confusion if anything went wrong….  Also used existing holes for the lines.  PM me if you would like more details or photos.

Joe

[mike dominick]

Put mine on today.

[mike dominick]

I drilled high up on the transom and ran the lines through, still need to silicone the bushings and push them in.

[mike dominick]

I put a pump on each side.

[mike dominick]

Foot pedals on the shelf up front

[jclacy]

Mike,

Thanks so much for being the “guinea pig” on this project.  I had decided that holes would have to be drilled but kind of dreaded doing so.  Your setup looks sweet and the excellent pics will help tremendously.

[mike dominick]

If you look at where the screws are in the gas tank selector you can gauge where to drill, that level was free of wiring and gas lines on my boat.  I started with a tiny pilot hole and went up in size very gradually till I got to the 3/4 drill bit.  I used 7 foot lines instead of the 11 footers that are stock, so I didn’t have all the excess.

[Author]

Posts