putting in new fishfinder at bow

[Bass Cat Boats]

Pull that power from either the accessory switch, if you have one. Or you can pull from a courtesy light.

The Trim buttons will supply you with a hot wire all the time, and a ground can come from the Navigation light. Though the trim is not through the Master Power switch.

BCB

[JMTFrisco]

My son installs Avionics on helicptors and we are installing an X-51 at the trolling motor and an LMS 520c in the dash. We were both very surprised to find so many slices in the wiring at the front of the boat and under the dash. I am the second owner of my Sabre. I bought it from a Bass Cat Rep. 5 years ago. Is mine a fluke or does Bass cat typically use a lot of splices in their wiring? Not complaining at all, just very surprised due to the quality I have come to know from Bass Cat.

…………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………..

Jmtfrisco, Texas

[bgibson53]

I have run wires to the front switches on my Classic and have yet to run across any wiring that has been spliced.

[FishB8s]

Most likely the first owner spliced in when installing aftermarket electronics. I’ve added electronics to my Jag and have contributed greatly to the number of splices one would find under the dash. I tied my GPS and LCR on my console to the courtesy light. I tied my bow unit to the accessory switch.

…………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………..

Richard Bates
2000 Jaguar
225 Mercury EFI

[Chris4pt3]

Does the accessory switch pop out? Do you have to pull the trolling motor access plate off and run the wires through there? I need to install a x-102C up front on my boat. Should I just leave the factory x-51 wires in place, so I don’t have a hole?

…………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………..

2005 Sabre, 150 XR6, Minn Kota Fortrex with Lowrance electronics

[FishB8s]

I removed the trolling motor access plate and the panel that houses my switch. I had the most working room by removing both. Use the same wiring if compatible; otherwise use your old wires to pull your new wires through existing wiring holes (usually located under your mount or under a decorative cap). Visible mount holes that didn’t match up to your new mount are easily filled w/ gel found in inexpensive patch kits.

………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………….

Richard Bates
2000 Jaguar
225 Mercury EFI

[Author]

Posts