Owner's Board

reel protector pad installation

I ordered the reel protector padding for my cougar and it came in 3 pieces. Does anyone have a picture of how they install, I know the big piece has to be positioned above the boat capacity plackard. The long narrow piece obviously is for where the rods lay but unsure where the small 4x5 retangular piece should go. Any help would be greatly appreciated!

This topic has 4 replies, 3 voices, and was last updated 11 years ago by Bass Cat Boats.

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
April 30, 2014 at 6:26 pm #343218

bazcat
Participant

Nobody else add this to their boats. I thought it would be a neat addition to keep fishing partners reels from scratching the fiberglass.

April 30, 2014 at 11:32 pm #343232

jbassertn
Participant

that rectangular piece goes next to the seat where the rods would lay i put the side piece on only have not had a problem does shrink a little but cleans up what kind of problem did you run into

April 30, 2014 at 11:55 pm #343256

Bass Cat Boats
Keymaster

I havent installed it yet so no problems. I figured the long narrow piece would go next to the seat for the rods to lay on. Just couldnt figure out where the small piece fits in. I was kind of hoping basscat boats would chime in on how the 3 pieces went. I guess I will just call the parts department. Thanks again.

May 1, 2014 at 12:37 am #343281

Bass Cat Boats
Keymaster

How about checking the locations in images on the Bass Cat Boats BCB Facebook by Serial Number site.
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic. Login Register