Owner's Board

Running Cable

Replacing side imaging TDucer on 09 Puma and have hit a wall. Normally can attach new wire to old and pull through. Tried and it hangs. Actually old transducer wire hangs at a point and absolutelly will not budge, trust me I tried. Now can not get snake from front to back or back to front. Any help would be appreciated.

This topic has 2 replies, 3 voices, and was last updated 15 years, 11 months ago by iceman.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
May 12, 2009 at 11:13 pm #323010

Bass Cat Boats
Keymaster

It is probably lodging in the rear corner and catching on the cable ends. It could also be in between wires and wedging.

May 13, 2009 at 2:55 pm #323024

iceman
Participant

I ran a snake through the back vent up to the console, like BCB said, with a line attached to it then attached the transducer end on it and ulled it right through with minium hang ups. It will take 2 people though so that the cable can be feed to you. Good luck
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic. Login Register