Topic: Strange Lowrance issue!

Strange Lowrance issue!

Went fishing today and when I turned on my 332C I got a nice map of the lake. Only problem was I was on Old Hickory and the map was Percy Priest!! Here is what I tried with no success. Turned it off and back on several times both with and without motor running. Took the LEI chip out and back in. Looked at all the optional pages, all seemed to be working, sonar was fine. It comes up and says it has found WAAS etc, and it shows up on the info screen. One ther thing I tried was to go to the information screen and watch the volts. This shows 13.5 volts with the motor running and drops to 12.4 a couple of minutes after shutting motor down, low battery? The crank battery is 3 years old. Everything else was fine, motor started right off. Another strange think was the Percy Priest was not the last lake we fished. Oh and you dont even need to ask the fishing stunk! Suggestions???

This topic has 4 replies, 3 voices, and was last updated 17 years ago by BTune.

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
April 30, 2008 at 10:42 pm #266949

4Bassin
Participant

Lowrance has a unique setup that sometimes show the last lake you are on. Power it up at home and watch the screen. It will still show the lake. Hit the exit button and it will go to the current page and your current location. I had a similar situation with my 111C-HD on Lake Hudson in Oklahoma when the Tablerock map appeared. Pressing exit cured it. ….

April 30, 2008 at 10:42 pm #266950

basschaser
Participant

Press Exit…sometimes it will cycle between where you moved the cursor to last and where you are. Just a shot but it might work, my first thought was it had never locked and that was the last place you had been but you said that wasnt the case so I would try the Exit button. I hope that works, sounds weird. Judd Lasiter

April 30, 2008 at 11:17 pm #266951

BTune
Participant

Thanks I will try that tomorrow. It will not do anything in my basement!

May 1, 2008 at 9:15 pm #266952

BTune
Participant

Thanks guys. I turned the 332C on and hit the exit button. That did it. Wonder what caused this issue, memory full?? Even caught a few with the winds at over 30 mph!!
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic. Login Register