Topic: Talon bracket for Eyra

Talon bracket for Eyra

For a side jackplate mount on a Bass Cat Factory Manual Jack Plate. What would be the offset to use for the new Talon Bracket? Boats in storage so I cant get the measurement. This will be for the mount that mounts directly to the side of the jackplate. Thanks!!

This topic has 2 replies, 2 voices, and was last updated 13 years, 3 months ago by Caldwellj.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
February 2, 2012 at 11:24 pm #361958

badhabitfishing
Participant

I ran over to my boat in storage so I can measure for the bracket that I need. I thought I had it figured out with a 6″ offset bracket. I just read your above post and that model number is for a 3″ offset bracket… So Im confused. Even more confusing is that I did a search and found basscat put together a guide on brackets and they say a 9″ offset. I may be just measuring the offset wrong. I measured from the centerline of the side jack plate slider bolts to the back of the boat…. Please let me know what Im doing wrong. Thanks!

February 3, 2012 at 2:14 am #361961

Caldwellj
Participant

If you are running the 8″ slide master manual jack plate…which I am pretty sure you are, you will need the 9″ set back on the side mount. That is the same that I ran before I went to a hyd plate.I am running a Puma FTD but I dont think there is much difference at the transom between the Erya and Puma. There was no way I could have run a 6″ setback. Jamey http://images.yuku.com/im…6c27aea485688b09ac_t.JPG Im on my iPad so I cant post pic but here is a link…think this should work. That is the side mount 9″ setback on a Slidemaster 8″ manual jack plateLast edited by Caldwellj on February 3rd, 2012, 2:38 am, edited 1 time in total.
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic. Login Register