Owner's Board

TM wiring

2010 Puma FTD.. I am going to go to 36v from 24v..Is the wiring that runs from the batteries up to the TM heavy enough guage from the factory to run a 36V MG 109???Thanks

This topic has 4 replies, 4 voices, and was last updated 12 years, 5 months ago by BamaCat.

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
December 4, 2012 at 1:15 pm #299914

Bass Cat Boats
Keymaster

Your wire is actually taxed less in most cases on the 36 volt system than the 24 volt. Not on high bypass though in average use you will use less battery on same speed or movement settings. Your fine other than needing a new 50 amp breaker for high speed use.

December 4, 2012 at 1:39 pm #299915

brnzbaklvr
Participant

Thanks..

December 4, 2012 at 2:26 pm #299916

BIGCATTER
Participant

After you get it on the water , be careful when applying full power . — If its turned sideways you can get wet in a hurry , as well as embarassed all to h— . — Hoss

December 4, 2012 at 4:03 pm #299917

BamaCat
Participant

BIGCATTER wrote: After you get it on the water , be careful when applying full power . — If its turned sideways you can get wet in a hurry , as well as embarassed all to h— . — HossBeen there and bought the shirt on that one!! Good advice to one and all.
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic. Login Register