Sorry, but I dont know how to tell. They look like standard guages with an arm that moves along dial if that is any help.
Please tell us that you released this fish
Could you post a photo BCB?
I have an HD7 using that mount. It holds it very well.
Is this boat still available?
anyone?? Bass Cat??
Someone, somewhere, must have mounted an HDS 5 on the bow of a Sabre
Thanks. Ill will likely use screws to hold mine in. I am not going to drill holes if I dont need to.
I swapped to a 52″ minn kota from a motorguide. The holes do not line up. There are 2 sets of holes in a minn kota, one is for mounting, and are reinforced holes, and the other are not nearly as sturdy looking. I drilled 5 new holes, reinstalled with aluminum plates that came with the motor guide, and fabricated 1 new plate. The mk needs 6 bolts, mg only 4. I also use a short arm ram mount to hold the motor down securley when travelling in rough water. It keeps it from bouncing up and down.
Use a rail mounted RAM. No holes to drill.
2006 Sabre w/ 2001 150 EFI. Engine was 0 hrs installed on hull in 06. I would guess 30 hrs now. Tandem trailer, deck extension, hot foot, hydraulic steering, Minn Kota, Lowrance HDS5 & 7. Excellent condition. What are you thinking for a trade? Blueberry hull, white cap
I prefer the rubber bungee straps
I use it in my 150 EFI. Seems to work fine and the reports I have read say it is a good oil.
RAM D 235Uhttp://www.ram-mount.com/CatalogResults … fault.aspxI use this with an HDS 8 and it works great. No holes to drill either.
http://www.ram-mount.com/CatalogResults … fault.aspxHolds my HDS 8 fine
© 2024 Bass Cat Boats