Owner's Board

Trailer front cross member keel roller addition?

I have a 2017 Bass Cat trailer that does not have the front cross member roller. It is a flat pice of rubber screwed into the frame. Is there an adapter bracket made to change this out to a keel roller, like the back roller? Either a u-bolt bracket or something that screws into the existing holes for a roller bracket conversion? The 2 screw holes width are 4 3/4" on center. The front cross member frame height is 3" and the depth (width) is 1 1/2".

Tagged: Trailer front cross member keel roller

This topic has 1 reply, 2 voices, and was last updated 4 months, 2 weeks ago by Rich12.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
August 29, 2025 at 7:58 pm #728933

strutin22
Participant

I have a 2017 Bass Cat trailer that does not have the front cross member roller. It is a flat pice of rubber screwed into the frame.

Is there an adapter bracket made to change this out to a keel roller, like the back roller? Either a u-bolt bracket or something that screws into the existing holes for a roller bracket conversion?

The 2 screw holes width are 4 3/4″ on center. The front cross member frame height is 3″ and the depth (width) is 1 1/2″.

August 30, 2025 at 9:05 am #728942

Rich12
Participant

You will more than likely tear up the bottom of your hull. A roll there would be impossible to see when loading and you will miss it more than hit it.
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic. Login Register