07 puma bilge pumps

[scsiman411]

I am at the Stren in Zapata and both my bilges quit. I need to get some information on how to get the issue fixed as the lake has been riding high the last few days with 25+ mph winds. Since both failed at the same time I am assuming that the pumps themselves are not the issue though that is a possibility. The indicator light on the dash is on. I looked for an inline fuse but I am unable to locate one. The event starts tomorrow and I could use some advice ASAP. My contingency plan is to unplug the recirc pump and put it in the bilge slot if all else fails and the pigtails are long enough if it is the same pump. Thanks in advance for any help Mike Haggerty 925-858-2890

[basschaser]

Mike – that is one way to check it the other way is to unhook the pumps from the housing and unplug them. Then wire them straight to the battery. If they run then it isnt a pump issue and you need to start tracing wires. When it gets to the A10 dash BCB will have to chime in. You should be able to wire around the dash but I havent messed with the dash enough to know how to do it. I probably should in case I am in your shoes. Good luck in the Stren!!!! Judd Lasiter

[Bass Cat Boats]

FIXED!! Steve Eidson and Michael Redfearn, you both rule. Thanks for your help and I cannot thank you enough.

[Bass Cat Boats]

Plus your pump out on the side into one of the bilge wires and you should be good to go with one pump. It could handle a load of both if you decide you want to Yoke them together. We suspect you have an issue that is unrepairable at Zapata. BCB

[Author]

Posts