AUX Switch on Dash, Blue Water LED Install

[downislandliving]

I have a 11 PII. I am installing some Blue Water LEDs this weekend. I want to attach them to the AUX switch on the dash. Is that switch powered or is it really just a switch? And if it is just an on/off switch, where up there would be the best spot to get power from?

[polaris425]

Its already powered… Just look for the pigtails under the dash… On my sabre it was the orange wire, even already had a but connector attached…13 PIV w/ 200 MercIG: WarriorRiverCustomRods

[polaris425]

Any luck?13 PIV w/ 200 MercIG: WarriorRiverCustomRods

[downislandliving]

No I cant see any spots to plug something in so I can use the AUX on my A10 touchpad to switch them on and off.

[Sparker]

If you have the round pump in/pump out/security module, there is an orange wire hanging from the connector powered through the accessory switch. On my A10 the accessory switch is in use, otherwise I think there would be an empty wire hanging off the harness. These unused switch wires do come with a butt connector, ready to plug in.

[downislandliving]

Thanks Sparker. I will look for that.

[btoth83]

I curious about this also. Can you tie into the ACC button on the round pump in/out module without affecting the operation of the security system?

[sdfd504]

Yes that is what the open switch is put in place for. Any item that you want to install down the road you can tap into the power with that open switch. On my 07 PII it was an pink wire as well with a yellow butt connector i believe.

[downislandliving]

Sparker wrote:If you have the round pump in/pump out/security module, there is an orange wire hanging from the connector powered through the accessory switch. On my A10 the accessory switch is in use, otherwise I think there would be an empty wire hanging off the harness. These unused switch wires do come with a butt connector, ready to plug in.Sparker you were spot on. Thanks a bunch, I will try to get some pictures up in the next few days.

[Author]

Posts