Last edited by 02bfishn on January 21st, 2009, 5:13 pm, edited 3 times in total.
Last edited by 02bfishn on January 21st, 2009, 5:15 pm, edited 1 time in total.
Thanks for the plug on my boat guys…appreciate that http://basscatowners.yuku.com/topic/7231 Derek – give me a yell if you would like more info or pics. Its in very good shape – not opposed to meeting you someplace in between if that helps. Charlie 314-420-1453
Last edited by 02bfishn on March 5th, 2009, 1:40 pm, edited 1 time in total.
Last edited by 02bfishn on March 5th, 2009, 1:39 pm, edited 1 time in total.
3/3/09 – Boat is Sold..1998 Basscat Pantera Classic (19), 2000 200 EFI, 2003 Disc Brake Trailer, 74lb Minnkota Maxxum. Lowrance X75 up front, Eagle Ultra Classic & LCD Flasher on dash, Hot Foot, Turn Signal Trim, Flippin Deck Extension, Rod Organizer, Custom Cover, 2 Matching Butt seats and 1 Sit Down seat, Propole, Dualpro onboard charger, Delco Voyager Maintenance Free Batteries, etc. Garage stored and meticulously maintained, looks great, runs great, ready to fish. Last edited by 02bfishn on March 5th, 2009, 1:38 pm, edited 1 time in total.
Last edited by 02bfishn on March 5th, 2009, 1:37 pm, edited 4 times in total.
Fortrex on my 06 Sabre no problemo.
Cable assy / plug – its close – pedal assy mounted all the way in the rear of the tray and to the right the cable assy goes right over the top of the wires coming out of the plug. Heres some pics; Last edited by 02bfishn on May 25th, 2011, 1:59 am, edited 1 time in total.
No Motorguide – had Fortrex on it when I got it.
Added online images – see them here;http://www.cboutdoor.com/2006sabre.htm
Boat is sold[font=ARIAL,SANS-SERIF][/font]Last edited by 02bfishn on January 20th, 2013, 3:28 am, edited 1 time in total.
Just went through this on my 96 PII to lube the cables.-Loosen motor to jack plate bolts (leave nuts on)-Loosen jack plate side bolts so you can change height (mark jack plate height setting first)-Floor jack under lower unit with piece of wood to protect it-Turn steering so rods going into motor are fully retracted – shortest lengthBetween adjusting the jack plate height, moving motor on the loose bolts (wood shims on one side between motor and jack plate), and using the trim, I was able to get the right angle of the dangle to get the rods in / out without too much heartache.
Seats are sold.
Couple more photos of Jeffs boat;
© 2024 Bass Cat Boats