Owner's Board

basscat247

Forum Replies Created

Viewing 15 posts - 1 through 15 (of 503 total)
  • Author
    Posts
  • #446917

    basscat247
    Participant

    Also have a 26″ tempest if anybody is interested. Make me a decent offer on either one of them. Thanks

    #446857

    basscat247
    Participant

    This trolling motor is less than 6 months old and looks like brand new. Somebody make me a decent offer and will consider it. Thanks

    #446859

    basscat247
    Participant

    No, it is a 36V Digital with a 42″ shaft. I think it is either a 105 or 109 pound thrust. Let me know if you are still interested and can send you some pics. ThanksJoey Watts

    #446645

    basscat247
    Participant

    I have a 26 Tempest for sale that looks like it is in very good shape. I just bought a Puma and it came as an extra prop. I am selling it and a 25 Tempest so that I can buy a 27 Trophy. Email me at my home email address and I will be glad to send you some pics. I am trying to get 300.00 for either one of them including the shipping cost. ThanksJoeyEmail: hav2fish247@aol.com

    #446918

    basscat247
    Participant

    Made a mistake on my first post. I have 2 props for sale. They are both tempest props and 1 is a 25 and the other is a 26. Thanks

    #446861

    basscat247
    Participant

    This trolling motor has been sold. Thanks

    #446443

    basscat247
    Participant

    Ryan, if you are still interested in trading, I have a 25 Tempest that I would be glad to trade or sell. I live just outside of Memphis in Byhalia Mississippi. Email me at hav2fish247@aol.com if you are interested. Thanks

    #446741

    basscat247
    Participant

    Sorry, have sold both these props.

    #324782

    basscat247
    Participant

    It has got me confused. Last time I charged Batterys one of the batterys never took a charge on the 36V part. I put a meter to it and it showed that the charger was not charging on that battery. The other 3 had a little more voltage than this one did. I disconnected the 36V jumper and it started charging. I went fishing yesterday and hooked up the charger again this morning and 3 of them charged very fast. Faster than I think they should have and the other one shows it is not charging. I disconnected the jumper and it still is not charging. Think maybe you are right and I have some cabeling issues but am not sure where. This thing looks like all the cabeling was done at the factory. Very neat and very tidy. I followed all the cabeling when I hooked up the new one so I am assuming everything is correct but will have to do some investigating. Thanks and if anybody else has ever experienced this please let me know what you found out. Will post again when I figure out what is going on. Thanks

    #324867

    basscat247
    Participant

    Thanks for the quick response. I understand now what you are saying. Yes, I do have a little bit of an electrical backround. I have an Associates Degree in electronics although it is not the field I now work in. Kind of weird to me also to have 2 of them bad like this but even stranger to have them both doing the same thing but on different outputs. I am just checking the output voltage of the charger when I plug this thing in. The other 3 jump up a little bit when I plug it in and this one is never jumping up. Even after I charge it manuially and know for sure this battery is charged I can plug the battery charger back on and the light will stay red. Maybe there is a little bit of a drain coming the front of the boat and am going to use this thing again over the holidays and then will try what you are suggesting. Hopefully I can figure this thing out before I go swapping it.

    Thanks again and will let you know what I come up with.

    Joey Watts

    #446670

    basscat247
    Participant

    I ran a 27 Pitch Tempest this past weekend on my Puma and 225 XS. Hole shot suffered just a little but think I was running the wrong vent plugs. Was running the small holes and am going to try the large holes this next weekend. I have the jack plate set about 1/8 up from the bottom and think I need to go down 1 or 2 turns. Motor was blowing out if I got in the trim to much. Over all performance was great, mid range punch was excellent and had her running a little over 74 on GPS. Is the bext prop I have run so far. Think I am going to order a 27 Trophy for this rig and those are the 2 props I will run. Gary, Thanks again for all your help with setting this boat up. For the most part you have been dead on !!!! Great boat and motor combination. Thanks

    #446600

    basscat247
    Participant

    You need to provide more information. What kind of boat, size of motor, how many rpms you are turning and anything else you can think of. Then somebody on here can and will provide you with a little help. Good Luck

    #446602

    basscat247
    Participant

    I do not have much experience with the set up of what you have. But in most cases going down on the jack plate will give you a better hold shot. Also going down in pitch on prop will give you a better hole shot.Also a 4 bladed prop is going to come out of the hole a little better than a 3 blade. I am not sure what your wide open throttle range is but sounds like you need to get that up a little and going down in pitch on prop will help this also. You might want to try posting this question on the owners board. I feel sure you will get somebody to respond that has your set up and that can help you out a little more. Good Luck

    #446409

    basscat247
    Participant

    This comes with a 3 year warrenty !!!!

    #446410

    basscat247
    Participant

    Somebody make me a decent offer on this charger. Not doing me a bit a good setting in the middle of my floor. Will consider any decent offer made on this charger. Thanks

Viewing 15 posts - 1 through 15 (of 503 total)

Skip to toolbar