Guys, I have been following this thread for a while. I have an 08 P2 with a 200 Optimax, 6″ slidemaster set flush, haven’t actually measured the prop to pad dimension. My boat is a dual console, run an Ultrex 80 with Mega 360 and Livescope, Helix 10 and Garmin 93SV up front. I have my girlfriend with me almost 100% of the time when I am out on the water, she is an absolute fish head like me so its awesome. I should mention I also run lithiums for the troller and no pony tank.
When I bought the boat it came with a 26 Trophy Plus with the small hub and a blow-out ring, I think two solid plugs and two small plugs, will have to double check that. There are a couple of minor dings on the edge of two blades and it looks like there was some cup added to the prop at some point in its life. With that prop I have ran up to 70.6 by myself and usually max out about 68 at 5500 rpm with both of us in there and running light on tackle. Most of the time in the summer running loaded we are hitting 66ish at about 5350 rpm. I know I run heavier than a lot of BCB owners.
I have a 26 Trophy Plus with the large diameter hub (no blowout ring required) that is in perfect shape, haven’t run that prop yet. Because of the loads I typically carry and fishing a lot of lakes that don’t allow for long top end runs and some speed limit lakes, I ended up getting a 24 Trophy Plus (large diameter hub) to try out this year. I figure that will get me back up into the sweet spot for the Optimax and maybe improve holeshot and midrange control. The 26 I have been running is an impressive prop but the holeshot has suffered based on load. I am hoping to get out this weekend with the 24 on there and will test the 26 with the large hub as well.
It seems that there is some experience in this thread with both the four strokes as well as the older 2 strokes. Has anyone compared the differences between the smaller diameter hub Trophy Plus vs the larger diameter hub? The smaller ones I have seen all run the blow out ring and they have a little bell flare at the back end of the hub where the large diameter doesn’t have that bell flare. How much of a difference does the cupping make on those props for the P2? When sending a prop to Ronnie for work, can he add a 1/2″, basically make the 24 into a 24 1/2″ I think that might be the sweet spot for how I run the boat.
Thanks guys,
TDobb